This article will show you how a tile wall detail is installed on a tile roof system. Keep in mind there are other methods used depending on what type of wall you are tieing into. In this example the roof detail will be lathed and stucco applied over the top. The roof flashings will be behind the lath and stucco. This is how a new constuction stucco home in Arizona would be done.
Step #1.
Your underlayment is installed and nailed, the underlayment type will vary. Typically a 15# or 30# organic felt is used this is the most common.
Tile underlayment
Step #2.
Next we install a J-pan metal and nail it to the wall over the top of the underlayment this metal allows water to run off the roof.
J-pan Metal
Step #3.
Next we are going to flash over the top of our J-pan with another metal called Z-bar.
Z-bar flashing
Step #4.
Now we apply a waterproofing paper over the top of our Z-bar.
Waterproofing paper
Step #5.
Our tile roof wall detail is now complete. Next we will lath and stucco our wall and lay the tile and the roof is correctly installed.
Finished tile wall detail
There are other methods to do wall details as well. This example was used because it’s a common method used in the southwest. Whatever method you use the principals are all the same. The underlayment always has a flashing over the top.
Description:
Tile roofs come in a variety of styles and materials. They consist of one piece “S Tiles” that are seen on many office building roofs. There are two piece tiles, called “Pans and Tops,” that are placed on Spanish style homes. The tiles are made of sand-cast, fired clay, concrete construction, and “light concrete.” All tile roofs require roofing felt underlayment, because the tile is simply a decorative watershed.
Uses:
Tile is installed most often to add beauty to a building project. Tile roofing by itself is not waterproof. A felt underlayment is required.
Approximate Life Span:
Some tile manufactures proclaim their products have a 50 year life span. The underlayment felt usually needs to be replaced on or before the 18th to 25th year. The existing tile can be reinstalled over the new felt. The slope of the roof is a determining factor in the life expectancy. The greater the slope, the longer the felt will last.
Caution:
The Uniform Building Code has very specific installation procedures for mechanically fastening tiles in place. Our experience has shown that approximately 75% of the tile roofs that have been inspected do not meet the Uniform Building Code. These tile roofs lack the necessary perimeter mechanical fasteners.
Limitations:
- Slope requirements for the installation of tile roofs are a minimum of 3 inches of vertical drop for every 12 inches of run in order to meet the local building code and have an effective waterproof system.
- Tile roofs are difficult to walk on and break easily, especially the sand-cast and clay varieties.
Comments (0) 
